occupied, time to setup Cisco VIRL

I’ve been occupied with many other things going on lately especially with the holidays. Family, work, etc. I haven’t been able to sit and write, but I ran into something pretty cool that I wanted to share. Those of you who are always looking to expand your knowledge in networking, cisco just released VIRL or virtual internet routing lab. This is Cisco’s newest virtualization lab simulation tool. It reasonably priced as well.

I saw this as a perfect opportunity to build a homebrew cisco VIRL¬†hyper-v server. Unfortunately hyper-v isn’t supported, but that didn’t stop me. I recently found a dell studio 435 with an i7-920 processor in the garbage down the street. The only issue it had was a dying power supply.

cisco VIRL home server

Once that was fixed, I started to install hyper-v 2012. To my dismay, I couldn’t get hyper-v loaded without the installation crashing. All settings looked to be good. Virtualization was enabled in the bios and all other recommended settings were set. I then realized that the bios version was pretty old and figured I try to do an update. Low and behold a bios firmware fixed the crashing issue. I slapped another broadcom pci-e nic and finished the install. Now I’m having issues getting the broadcom nic and the onboard nic to load correctly. After searching the Internet, I figured out how to manually add drivers in hyper-v core mode. I’m still running into some issues with NIC detection, so I think I may run esxi on another partition of the drive just to get VIRL running. Stay tuned….

You can now follow up on my cisco bare metal home build here.

 

One comment

Leave a Reply

Your email address will not be published. Required fields are marked *